Simple instructions for setting up the HP Envy Pro 6458. We demonstrate how to connect your printer to computer and install it. Click here for more information.

1. Hp Envy Pro
6458 Setup
howtoadd.net

2. Connecting the power
cord:
Loading the paper:
Hardware Setup
Plug the power cord to the rear of
the printer and the other end into an
electrical outlet.
The printer will now turn on
automatically.
Now, a purple light will flash at the
center of the printer.
First, you need to pull out the input tray from the HP
Envy Pro 6458 Setup. Next, slide the paper width guide
as far as possible.
Next, insert the sheets into the paper tray and adjust the
paper width guide until it stops on the edge of the stack.
Avoid loading the sheets above the load limit mark.
Close the input tray.
Unpack the box and remove the HP Envy Pro 6458 Setup documents,
power cord, and ink cartridges from the package.
Slowly pull the printer out of the pack.
Remove the foam packing material from both sides of the printer.
Next, uncover the printer from the plastic bag.
Discard the blue protective tapes around the HP ENVY Pro 6458 printer.
Next, open the ink cartridge access door of the printer and remove the
protective tapes.
Open the scanner lid and discard the foam sheet from the scanner glass.
Unboxing the printer:

3. Press and hold the Wireless and Power buttons together for at least three seconds on your
HP ENVY 6458 printer to begin the WPS push button method.
On the router, press the WPS button.
The outside edges of the light bar will glow in purple once the printer is connected to the
Wi-Fi network.
If your router does not support the WPS push button, follow the below instructions to use
the PIN method.
Press and hold the Information button on your printer until the light blinks on all the control
panel buttons on your printer.
Next, press and hold the Information and Down arrow buttons together for five seconds on
your HP ENVY Pro 6458 printer to begin the WPS PIN method and print a page with the
PIN code.
Now, the outside edges of the light bar will glow purple on your printer.
Next, open the configuration utility or the software of your wireless router or wireless
access point and enter the WPS PIN.
Now, wait for connecting your printer to the wireless network.
When the printer is connected successfully, the light bar will glow white in the center of
your printer.
HP ENVY PRO 6458 WIFI SETUP

4. Get in touch
with me
For inquiries on my services
Website:
https://howtoadd.net/hp-envy-pro-6458-setup